News
Kawan Green Energy S/B listed under
MyHIJAU Mark
November 2022 • Uncategorized
KAWAN® listed Manufacturer & Assembler(LMA)
under SEDA
May 2021 • Uncategorized
KAWAN® secure Biogas Purification project
May 2021 • Uncategorized
National Board ‘R’ Stamp Acquisition
2020 • Uncategorized
55% Engecrol Moditech
3rd & 4th Biomass Power Plant
2018 • Uncategorized
Ta Chang - BioMass
Power Plant.
FGV - PKC +
Govi - Special Lubricant / Solvents Plant
2016 • Uncategorized
CJ Bio - Fermentation projects
April 2013 • Uncategorized
KAWAN® acquired another 2 acres piece of land and built fabrication yard with built-up area of 44,907ft2 (4,172m2).
Year 2011 • Uncategorized
One of KAWAN® products - Boiler is accredited by American Society of Mechanical Engineers (ASME) as authorized to use the indicated symbol "H" and “S". All the heating boilers and power boiler are manufactured and tested in accordance with the A.S.M.E. Boiler and Pressure Vessel Code.
May 2011 • Uncategorized
KAWAN® had obtained certification of ISO 9001:2008 on the area of design, manufacturing, on-site commissioning of pressure vessel, heat exchanger system, water & waste treatment equipment and process equipment.
On 17th August 2009 • Uncategorized
KAWAN® was awarded a license by Department of Safety & Health (DOSH) Malaysia to design and construct hot water boiler, thermal oil heater and coiled once-through boiler.
October 2008 • Uncategorized
KAWAN® signed the agreement with the New Zealand manufacturer for the transfer of the manufacturing plant and intellectual property comprising Thermal Oil Heaters, Hot Water Boilers, Steam Generators and Air Heaters to Kawan.
April 2008 • Uncategorized
KAWAN® built the forth Biodiesel and Vitamin plant for Caroteh Berhad amount to RM 100 million.
In 2007 • Uncategorized
KAWAN® introduced a quality management system based on the requirements of ISO 9001:2000
International Standard.
In 2006 • Uncategorized
KAWAN® built the second Biodiesel and Vitamin plant for Carotech Berhad.
In 2004 • Uncategorized
KAWAN® is authorized to apply "NB" Mark and register Boilers, Pressure Vessels or Other Pressure Retaining Items with The National Board of Boiler & Pressure Vessel Inspectors in accordance with its provisions. The scope of Authorization is limited to items manufactured in accordance with ASME 'U', 'S' & 'H' Stamp.
KAWAN® had obtained Manufacturing License for Pressure Vessels, Heat Exchangers, Thermal Fluid Heaters, Boilers, Steam Generators, Economizers and Calorifiers, Deaerators, Waste Water Equipment and Process Equipment by the Ministry of International Trade and Industry, Malaysia (MITI) under The Industrual Coordination Act, 1975.
The Company name had been changed to Kawan Engineering Sdn. Bhd.
KAWAN® had obtained certification of ISO 9001:2000 on the area of design, manufacturing, on-site commissioning of pressure vessel, heat exchanger system, water & waste treatment equipment and process equipment.
One of KAWAN®’s product - Pressure Vessels is accredited by American Society of Mechanical Engineers (ASME) as authorized to use the indicated symbol “U”. All the pressure vessels are manufactured and tested in accordance with the A.S.M.E. Boiler and Pressure Vessel Code.
KAWAN® move to new premise. Operating in a factory lot of 2.0 acres, with an engineering crew of approximately 20 experienced and dynamic personnel, KAWAN® are able to customize design, fabricate, install and commission plants / systems.
KAWAN® built the third Biodiesel and Vitamin plant for Carotech Berhad amount to RM 40 million.
KAWAN® was awarded a license by Department of Safety & Health (DOSH) Malaysia to design and construct unfired pressure vessels. KAWAN® is also a license contractor for LPG/LNG piping, accredited by the DOSH and Class “B” Contractor accredited by the Department of Electricity and Gas Supply (JBEG).
With effect from 22nd June 2011 • Uncategorized
With effect from 15th December 2010 • Uncategorized
July 2009 • Uncategorized
On 1st August 2008 • Uncategorized
March 2008 • Uncategorized
In the fourth quarter of 2006 • Uncategorized
In 2006 • Uncategorized
In 1998 • Uncategorized
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
--------
Daya Bhd - Waste
Solvent Rectification & Incinerator
HTRI Members
ASME "S" "U" "H"
Orbiter Welding
DISH End Maker
SS Automatic Buffing
Iffco - Fatty Acid, Distillation, Hydrogenation, Soap Plant
CNC Plasma Welding
CNC Plasma Seamer
Automatic TIG
CJ BIO - Co Gent
Spray Cooling. Deglycerination.
Food Ester Reaction, Deodorisation, Bleaching
500 m3/hr -190 °C Hot Water Plant
2013 • Uncategorized
2015 • Uncategorized
2017 • Uncategorized
September 2018 • Uncategorized
KAWAN® celebrates 25th Anniversary.
KAWAN® was awarded a license by Department of Safety & Health (DOSH) Malaysia to construct and repair water-tube boiler, fired-tube boiler and Heat Recovery Steam Generator (HRSG).
April 2021 • Uncategorized
--------
--------
KAWAN® established Kawan Green Energy S/B
KAWAN® established Factory 3
May 2022 • Uncategorized
June 2022 • Uncategorized
--------
--------
--------
--------
Engineering and construction works for the production of Process Equipment commenced in early 1996
Manufacturing and Engineering Solution Provider in Malaysia
Copyright © 2023 Kawan Engineering Sdn. Bhd. (385603-U) All rights reserved.
Send Me Updates!
STAY IN TOUCH
Subscribe to our newsletter and get new posts straight to your inbox